How to use PhoenixSuit to Flash New Image to MarsBoard A10/A20

From wiki
(Difference between revisions)
Jump to: navigation, search
(Install)
Line 18: Line 18:
 
[[File:Upgrade-Guide-1.png]]
 
[[File:Upgrade-Guide-1.png]]
  
Select the Unknown device then right click and select "Update Driver Software".
+
During the installation process, it may require to install the driver as shown in the following picture, just select "下一步"(means Next) to install the driver as shown below.
  
[[File:flash_image_2.jpg]]
+
[[File:Upgrade-Guide-2.png]]
  
Select "Browse the computer for driver software".
+
The drivers were successfully installed on this computer as shown below. Then click '完成'(means Finish).  
  
[[File:flash_image_2.5.jpg]]
+
[[File:Upgrade-Guide-3.png]]
  
Find the file unzipped file you downloaded earlier (Rockusb_Driver_v3.7.rar) and select either the 32/64bit folder then click "OK" to install.
+
PhoenixSuit has been successfully installed as shown below, click "Close".  
  
When the driver is installed successful you will then see a Rockusb Device in the device manager window.
+
[[File:Upgrade-Guide-4.png]]
 
+
[[File:flash_image_6.jpg]]
+

Revision as of 04:27, 26 June 2014

In this tutorial, we will show how to use PhoenixSuit to flash an image to the nand flash of MarsBoard A10/A20.

MarsBoard A10/A20 requires PhoenixSuit version 1.0.7 to flash the nand image through MarsBoard A10/A20 USB OTG port. We need to download PhoenixSuit and install it first. During the installation, the software will prompt for if the driver is needed or not. Please always click ‘Yes’.

Before you start

Keep in mind that:

   You can always flash the MarsBoard, it never bricks (as the name :)) unless some hardware damage occurs.

What you will need to flash the board is:

  • a MarsBoard A10/A20 board
  • a PC running Windows (XP 32/64bit, Windows 7 32/64 bit)
  • a micro USB cable with one side plugged in to the OTG port of MarsBoard and the other side plugged into the USB port on PC.

Install

Download the file (PhoenixSuitV1.0.7) from here. Then unzip it and double click PhoenixSuitV1.07_EN.msi, you will see the following interface.

Upgrade-Guide-1.png

During the installation process, it may require to install the driver as shown in the following picture, just select "下一步"(means Next) to install the driver as shown below.

Upgrade-Guide-2.png

The drivers were successfully installed on this computer as shown below. Then click '完成'(means Finish).

Upgrade-Guide-3.png

PhoenixSuit has been successfully installed as shown below, click "Close".

Upgrade-Guide-4.png

Personal tools